Enterprise
In my aip project, I have a few prerequisites listed under post-install of the prerequisites tab. They install normally through Full UI installation. However, if I execute the installer as a Basic installation, the post-install prerequisites do not get installed at all even though the main installation installs fine. The command I run to execute basic installation is the following (powershell):
Code: Select all
.\app.exe /qb /passive
Here are the parameters and troubleshooting that I've done:
-Each prerequisite Install Command Lines are set with /qb /passive (and various install parameter assignment) for Basic UI
-Table Editor > CustomAction > AI_LaunchChainer type value was updated to 1266
-Installation Behavior (within Organization) is set to Not Installed with a condition check for Installed if: (The condition is simply checking the value of an install parameter)
-Everything was ran as admin
My question is how are we able to install post-install prerequisites on a Basic installation?
Links I have referenced:
viewtopic.php?t=35929
https://www.advancedinstaller.com/user- ... uestion123
https://www.advancedinstaller.com/user- ... uestion127
-Nick