derekjfrei
Posts: 1
Joined: Tue May 14, 2024 1:08 am

Can only install in debug mode after upgrading

I am working on upgrading a legacy project from Advanced Installer 7.7 to 21.7.1. After doing this, I can only install my application in debug mode (AI_DEBUGLOG=1). If I specify the debug flag, the installation works as expected. If I do not, the installation immediately shuts down, and none of the custom actions in my project are executed. Any advice on troubleshooting this would be appreciated.
Catalin
Posts: 6721
Joined: Wed Jun 13, 2018 7:49 am

Re: Can only install in debug mode after upgrading

Hello and welcome to our forums,

I'm afraid that considering the discrepancy between the two versions you are using, I can not really say for sure why this is happening.

If possible, could you please forward me the following resources:

- a copy of the AIP file used in 7.7

- a copy of the AIP file used in 21.7.1

- a download link for the setup (built with 21.7.1 after upgrade)

by email at support at advancedinstaller dot com so I can further investigate this?

Best regards,
Catalin
Catalin Gheorghe - Advanced Installer Team
Follow us: Twitter - Facebook - YouTube

Return to “Common Problems”