phaniraj
Posts: 14
Joined: Wed Nov 21, 2012 5:47 am

Customize launch condition message

Hello,

We are using enterprise edition of Advanced Installer 9.6.1
We are creating separate installers for 32 and 64 bit using Advanced Installer and we have .NET framework 4.0 as pre-requisite

We only want 32 bit installer to run only on 32 bit and 64 bit installer only on 64 bit.
We have separate Advanced Installer projects for 32 bit and 64 bit.

When I run 32 bit installer on 64 bit machine (Windows 7), it shows the following message

[Product Name] cannot be installed on Windows XP/Vista/Windows 7/Windows 8 x64

I have modified the LaunchCondition table from the original message to

[ProductName] installation is only supported on 32 bit Windows Vista and Windows 7

The following options have been checked:
Prerequisites
- Check predefined launch conditions before searching for prerequisites

However, it does not show the updated message but instead shows the original message.

Attached is sample Advanced Installer project file.
How can we customize the message shown?
Attachments
Sample.aip
Sample project file
(24.43 KiB) Downloaded 470 times
Eusebiu
Posts: 4971
Joined: Wed Nov 14, 2012 2:04 pm

Re: Customize launch condition message

Hi and welcome to Advanced Installer forum.

This is the normal behavior for your project. When you have a pre-install prerequisites, your package turns automatically into an exe setup. You can see this in the Builds page. Also the exe packages have their own predefined messages that cannot be modified.

So, the solutions for your problem are:

1. You can uncheck the "Check predefined launch conditions before searching for prerequisites" option, but the inconvenient is that your prerequisite will be installed and after that the error message will appear.

OR

2. Move the prerequisite in the "Feature-based" folder and change your output to MSI from Builds page.

All the best,
Eusebiu
Eusebiu Aria - Advanced Installer Team
Follow us: Twitter - Facebook - YouTube

Return to “Common Problems”