Silent installation by passing parameters

[srujan.palakurthi]

Hi Catalin thanks for your response.

Actually once the silent installation completes than I have to run other interal powershell scripts.. those are not incorporated in installer right now and no plan for now.

So how can I make sure installation was completed and need to proceed with my powershell script running?

I hope this will clear for you.

Thanks,
Srujan.

[Catalin]

Hello Srujan,

Thank you for the explanation.

I have explained how you can verify if the installation was successful in my last thread.

I will paste it here just in case:

- you can check Control Panel and see if your application was installed

- you can check Event Viewer to see if your application was installed

- you can create an installation log and check it

Hope this helps.

Best regards,
Catalin