OptionalFeatsDialog not showing up in Maintenance

[mdesa]

Hi,

I configured my project (Enterprise) to use OptionalFeatsDialog in both First Time Install and Maintenance.

If I run "Test Installation/Maintenance UI", the OptionalFeatsDialog dialog is the same in both cases. But this is not the case when I really run the installer and the "Modify" mode after installing.

The "Install dialog" looks the same as in test mode, while the "Modify" dialog, in Maintenance mode, looks quite different.

Install:

Install2.png (24.14 KiB) Viewed 2870 times

Maintenance:

Maint2.png (24.67 KiB) Viewed 2870 times

Any hints?

Thanks
Marcello

[Catalin]

Hello Marcello,

That dialog is displayed like in the first screenshot due to the Enhanced User Interface improvements.

In your project, the EUI is most likely set only for installation.

You can see this option in the Themes page --> "Settings" tab.

Screenshot_9.png (13.27 KiB) Viewed 2839 times

After checking the "Always" option, the dialog should look the same in both first time install and maintenance.

Hope this helps!

Best regards,
Catalin

[mdesa]

I clearly missed that setting. It works as expected now.

Thank you.

[Catalin]

You are always welcome, Marcello!

Best regards,
Catalin