vaine0
Posts: 14
Joined: Wed Jul 09, 2008 11:40 pm

Help! Multiple Volume support

I have an enterprise project set up, and I'm trying to test the multiple volume support provided through Advanced Installer.

1) I have my first and next volumes both configured to 100 megs. My project split up into 2 different cab files, and a single MSI on build. The folders are labeled Disk1 and Disk2.

2) I build an iso image in 2 different failing ways:
a) With the root of the iso containing the folder, Disk1 and it's contents.
b) With the root of the iso containing only the contents of Disk1 (ie. only the cab and msi).
(repeat for Disk2)

3) I mount the first disk to a virtual drive and begin installing. I am prompted to insert Disk2, so I mount Disk2.iso to the virtual drive. I press ok, and am prompted to insert Disk2 once again. Repeat.

4) On my local file system I copy cab2 into the Disk1 folder. (cab1, cab2, and msi are now all in the same folder). I run the MSI, and the entire application installs fine. What is happening with the multiple volumes that I'm not understanding? As a side note, I did try all the above on physical media with the same results.
Cosmin
Posts: 5797
Joined: Tue Jul 10, 2007 6:39 pm
Contact: Website

Re: Help! Multiple Volume support

Hi,

Please note that the removable media must have the labels you use in your project (for example "Disk1" and "Disk2"). Make sure that the ISO images you are using have these labels (not some default label) and let me know if the problem persists.

Regards,
Cosmin
Cosmin Pirvu - Advanced Installer Team
Follow us: Twitter - Facebook - YouTube
vaine0
Posts: 14
Joined: Wed Jul 09, 2008 11:40 pm

Re: Help! Multiple Volume support

Thanks a ton. That fixed the issue.

Return to “Common Problems”