We’re moving our forums to a new platform.

You can still browse and search existing topics, but you can no longer create new topics or post replies.

For questions, technical issues, or feature requests, please don’t hesitate to contact our support team at support@advancedinstaller.com.

Thank you for your understanding!

mmadden
Posts: 22
Joined: Fri Jun 10, 2005 6:21 pm
Location: West Conshohocken, PA

Install Level (Custom-Typical-Full) Problem

Using the Eval Pro mode AIv2.6.5
-Not sure if eval mode has this feature disabled or if I am doing something wrong.

I created an MSI with four(4) features. I set the Install Level on 3 (three) of the featurs to be level 1 (Typical) and on the last one as level 4 (Complete).

In the Dialogs section I added the Setup Type Dialog.

When I run the MSI and choose typical- all four features are installed.

If I choose custom, the expected 3 (three) typical features are enabled while the fourth is disabled (this shows me my settings took effect somewhere). If I uncheck all but one feature-all 4 (four) features still install.

Am I missing a settig somewhere? Is this disabled in eval mode?

Thanks
Mike
Posts: 292
Joined: Wed Jun 01, 2005 10:50 am
Location: Craiova, Romania
Contact: Website

Hi Michael,

We weren't able to replicate this problem. This not a limitation of
the demo mode. So, if you could, please provide more details on what you did or send us the .AIP file that causes the problem.

All the best,
Mihai
Last edited by Mike on Wed Jun 22, 2005 1:04 pm, edited 1 time in total.
Mihai Bobaru
Advanced Installer Team
http://www.advancedinstaller.com
mmadden
Posts: 22
Joined: Fri Jun 10, 2005 6:21 pm
Location: West Conshohocken, PA

Thanks for the reply.
It really helps to know that its not a limitation in demo mode-Actually it does not appear that there are any limitations (other than the Eval reminder).

I figured out what this problem was as well. :D
It was related to the Organization/Features section. Apparently when I removed files from the 'Files' section, it also removed them from my organization structure. Then when I added the new files back in, they, by default, were placed in whatever the active "Current Feature" organization item that was selected.

Now I know, through trial and error, when I remove and readd files or reg entries, to first select the feature I want it to be a part of then add the files or reg entries or at leats be sure to move them back to thier appropriate feature after the fact.

Thanks.

Return to “Common Problems”