Hi
I am new to advanced installer, but have had a few succesful attempts of creating an msi.
I now face a more challenging install, and would like any helpful information before i start this project.
Basically my install needs to do the following;
First it needs to run a setup file to install a peice of software that we use.
Next it will install a visual foxpro front end that our software runs on
(Both of these files are .exe install files that have been created previously by the programmers of our software about 7 years ago)
The bits that I have no problem with are installing fonts into the windows fonts folder and creating the desktop and start menu shortcuts.
Ideally I would like to combine all the files that are installed in both of the .exe files and combine these into one install file that does the lot, along with fonts and shortcuts. The problem i have is that i dont know which files are installed by the 2 seperate .exe files, how can I find this out?
If i cant find out what files are installed by the 2 seperate .exe files, then the other way i would like to do the install is by making it launch each of the 2 .exe install files seperately via a custom action. I have tried this already, but it launches them both at the same time. Ideally i would like it to run the second .exe when installation of the first.exe is complete. How do i do this?
Finally, when the 2 installs have completed there are 2 more stages left to carry out.
A seperate .exe file needs to be copied over the top of the installed .exe file (An updated version of the software)
A group of files need to be copied from the installation cd to a folder on the machine the install is ran on, but these files need to be copied after the install has ran, as the files that need to be replaced are put onto the machine via the install in the first place.
Any help would be very much appreciated with this matter, and many thanks in advance.
FOLLOW US
Get the latest news in Application Packaging