AllanW
Posts: 20
Joined: Thu Feb 18, 2010 11:42 pm

MSI schema version

I've noticed that the database schema for my installs is 200 (reported by ORCA), despite specifying minimum Installer version as 3.0. This causes the validation suite that runs in Advanced Installer to generate few warnings such as:
Complete functionality of the MsiPatchCertificate table is only available with Windows Installer version 3.0. Your schema is 200.
Fortunately, I'm not using the tables that are mentioned so, as far as I can tell, this isn't an issue at the moment. Still, it would be preferable if the schema could be set according to the minimum Installer version specified, or something, so that those warnings could be eliminated and maybe prevent potential problems down the road (just in case).

Is there a way to specify the schema version in Advanced Installer? If not, might it be added in a future version?
GabrielBarbu
Posts: 2146
Joined: Thu Jul 09, 2009 11:24 am
Contact: Website

Re: MSI schema version

Hi Allan,

The warning you are referring to can be ignored. The table will be ignored if the msi is run with version 2.0 of Windows Installer or greater. We will add an improvement to enable you to set the schema in a higher version of Advanced Installer.

Best regards,
Gabriel
Gabriel Barbu
Advanced Installer Team
http://www.advancedinstaller.com/
AllanW
Posts: 20
Joined: Thu Feb 18, 2010 11:42 pm

Re: MSI schema version

Yeah, ignoring the warning is pretty much what I was doing. I just figured I'd make the request in case it was something that might cause problems for somebody (or me, for that matter) in another install.

Thanks very much for adding the improvement.

Return to “Common Problems”