install fonts that were used in setup dialog

[a.rasoulain]

Hi,
How can I install fonts that I'm used in my setup dialogs without using pre-install prerequisite section?
I don't want to use pre-install prerequisite section because I don't have any access on prerequisite dialog elements to personalize it for my native language.

any help will appreciated in advance

armin

[mihai.petcu]

Hi Armin,

I don't have any access on prerequisite dialog elements to personalize it for my native language.

I don't understand this reason. Can you please give me an example of what you mean?

If the target machine doesn't have your dialogs font installed and you're unwilling to use pre-install prerequisites, there's nothing much you can do. Also, I'm not sure the font will be available right away, the pre-install prerequisite may need to perform a reboot as well.

All the best,
Mihai

[a.rasoulain]

Hi Mihai,
my setup is in persian,but dialogs of pre-install prerequisite are in english, and as far as I know texts of these dialogs can't be change.
I use a persian font in my setup dialogs that probably there is not in the target machine , so I look for a way that automatically install that font before my setup dialogs will be displayed.
Do you have any suggestion for this scenario ?

thanks for your attention

have a good time

Armin

[mihai.petcu]

Hi Armin,

This is true, but you can set the bootstrapper silent(maybe the font installation as well) and the main installer with full UI. This setting is available from the Dialogs page -> Bootstrapper UI.
Set "Run as administrator" from the Install Parameters page if needed.

All the best,
Mihai