Hi,
We are using Advanced Installer 9.6.1.
We have created 2 installers (Supported OS: 64 bit Vista,7 & 8)
1. Wrapper Installer for device drivers (ImperiumDrivers_x64.exe)
This installer installs 3 device drivers on the client machine.
2. Main Application installer
This installs services & other resources required by the main application.
This also run the above Wrapper installer (ImperiumDrivers_x64.exe) as post-install pre-requisite.
Both installers reboot behavior is set to:
Suppress reboot after install, except for ForceReboot options.
None of the device drivers prompt for reboot and main installer also does not require reboot.
Observed Behavior:
Main application installer successfully installs & post-install prerequisite (ImperiumDrivers_x64.exe) installation is started.
After post install prerequisite completes, the application is ready to use & all device drivers are successfully installed as well.
Application is able to communicate with devices and works as expected.
No problems here.
However, if the machine is restarted by the user after successful installation.
On restart, the post-install prerequisite (ImperiumDrivers_x64.exe) shows up in resume mode.
I noticed that there is a scheduled task created when post-install prerequisite installation starts.
This scheduled task seems to be kicking off the prerequisite installer in resume mode after the system restarts.
As I understand, the scheduled task might be created to resume installation if reboot was requested.
Since the installation was successful, shouldnt this task be removed?
Thanks
-Phani
FOLLOW US
Get the latest news in Application Packaging