fuhrj
Posts: 13
Joined: Fri Jul 25, 2014 6:44 pm

Radio button "selected" status not saving on exit

I have a dialog that has two radio buttons.

I set the first radio button Selected property to True, save the project and build. Running the installer, the first button is selected which is correct.

However, after closing the project and opening it back up, the first radio button's Selected property is False and the second is set to True.

No matter how many times I click the Save button, it always reverts back to second radio button as being selected, when the project is reopened.

Any ideas on why it is doing this?

We are using AI v11.3. FYI, this project was build with AI 9 or 10, so it has gone through several upgrades.
Dan
Posts: 4530
Joined: Wed Apr 24, 2013 3:51 pm

Re: Radio button "selected" status not saving on exit

Hello and welcome to Advanced Installer forums,

I'm not sure why you encountered this behavior. I've tested your scenario but I cannot replicate it.

In order to have a better view about this, can you please send us the .AIP(project file) to support at advancedinstaller dot com so we can investigate it? If it contains confidential information you can send us a small test project which reproduce this behavior.

Best regards,
Dan
Dan Ghiorghita - Advanced Installer Team
Follow us: Twitter - Facebook - YouTube
fuhrj
Posts: 13
Joined: Fri Jul 25, 2014 6:44 pm

Re: Radio button "selected" status not saving on exit

Thanks! I just sent the project file.

I can't figure it out. I have another project that uses two radio buttons and the selected option state is always correct. Only this one it keeps switching to the 2nd option whenever the project is reopened.

Return to “Common Problems”