thenefield
Posts: 68
Joined: Thu Dec 06, 2007 6:19 pm

Stuck on "Removing backup files"

I have been using the installer for Windows XP and Windows 7 and have noticed allot of issues after the past couple of releases (12.7.1 * 12.8).

1) Windows XP installer stays on "Removing backup files" at the end of the install, never completing. This does not occur on Windows 7.

2) All of my prerequisites seem to have the logic messed up regarding the operating system to install on. I have some designated for Windows 7 only and some designated for Windows XP only. However all of them are getting triggered on both platforms. I am able to work around it by recreating all of my prerequisites, but what a pain it is to do after each release.

Lastly, what was the primary reason for removing Windows XP support prior to SP3? This has disabled my ability to deliver SP3 through the installer on a system that does not have it. Going back to version 10 just doesn't cut it for me as I have invested too many changes since then to my project file. It would have been helpful to know when that last supported release was pushed out that its support would be ending. No notification was mentioned until 12.8.
Daniel
Posts: 8283
Joined: Mon Apr 02, 2012 1:11 pm
Contact: Website

Re: Stuck on "Removing backup files"

Hello,
1) Windows XP installer stays on "Removing backup files" at the end of the install, never completing. This does not occur on Windows 7.
Can you please send us the .AIP (project file) and a verbose log of the installation to support at advancedinstaller dot com so we can investigate them?
2) All of my prerequisites seem to have the logic messed up regarding the operating system to install on. I have some designated for Windows 7 only and some designated for Windows XP only. However all of them are getting triggered on both platforms. I am able to work around it by recreating all of my prerequisites, but what a pain it is to do after each release.
I tested several scenarios with prerequisite installation but everything worked as expected. Can you please also send us for this case too the .AIP (project file) and a verbose log of the installation to support at advancedinstaller dot com so we can investigate them?

It will be very useful for us if you could isolate the error in a small buildable sample (AIP + its referenced file).
Lastly, what was the primary reason for removing Windows XP support prior to SP3? This has disabled my ability to deliver SP3 through the installer on a system that does not have it. Going back to version 10 just doesn't cut it for me as I have invested too many changes since then to my project file. It would have been helpful to know when that last supported release was pushed out that its support would be ending. No notification was mentioned until 12.8.
This happened because the Advanced Installer features you include in your built setups are not compatible anymore (starting with AI 12.8) with lower SP installed on XP and Server 2003 operating systems. We apologize for any inconvenience this changes have raised in your setup build management.

All the best,
Daniel
Daniel Radu - Advanced Installer Team
Follow us: Twitter - Facebook - YouTube

Return to “Common Problems”