Hello,
I was using Adv Installer 3.3.1, then upgraded to 5.0. I created new AIP files when I did this. The first few builds worked fine with 5.0, but then I started observing this condition where I would attempt to build and I would get here:
DefaultBuild
Building package (en): C:\Documents and Settings\xpuser\Desktop\VIEX Dists\VIEX-2.1.1\viex-2.1.1.msi
Applying file transforms... done.
Creating CAB file(s)...
The progress bar then "sticks" there for 15-25 mins, eventually I start to see these 2GB disk1.cab, disk2.cab files, etc. I then cancel the build and retry. It seems to want to create sequentially numbered cab files forever until I stop it.
Last week, I downloaded 5.1.1, and the first time I ran it with the 5.0 AIP, it worked fine. However, now, I am trying to run the EXACT same AIP and is reverting to the bad behavior mentioned above.
Any thoughts?
FOLLOW US
Get the latest news in Application Packaging