Converting Exe To Msi for silent install

[dlafontaine]

Hi,

I am currently using the Advanced installer trial version to test the functionnalities.
The exe to msi convert process is working fine.

If I start the .msi alone it goes through the installation process without problem except for the fact that it prompts this window:
This package was created with a trial version of Advanced Installer. You may use it for evaluation purposes only.


When I use the .msi with the silent switches(/qn) or (/q), the installer shows in Task manager for a while and then disappears after a few minutes but nothing has been installed. Is it caused by the trial version prompt?

thank you

[Liviu]

Hello and welcome to our forums,

To assist us in conducting a thorough investigation of this issue, can you please send us the .AIP (setup project) file and an installation log by email to support at advancedinstaller dot com?

Looking forward to hearing from you!

Best regards,
Liviu